Nitrogen tank and wires
I headed over to Action Gas and Welding which is a local gas and welding supply store to pick up a 10 lb tank and regulator. I had talked to the owner before and he is very helpful. They had a catalog for beverage dispensing but it didn't have fitting I needed for the valves but I found some really cheap at FiltersFast.com for $1.45 called "Liquatec Tite Grip Male Connector Fittings". Here is the tank hooked up to a water valve to test the flow at different PSI. Still haven't figured how much I should run but looking like ~5psi might be ok.
Also cleaned up some wiring on the water valves hooking the ground to the aluminum that the valves are mounted on and attaching the disconnects to the other wire.
Comments
No Comments, Please leave one below!
Leave a Reply
Sidebar Introduction
There are many variations of passages of Lorem Ipsum available, but the majority have suffered alteration in some form, by injected humour, or randomised words which don't look even slightly believable. If you are going to use a passage of Lorem Ipsum, you need to be sure there isn't anything embarrassing hidden in the middle of text.
